Find out how to get that dang thing to fit.
4 posts • Page 1 of 1
Hi! I need to shorten the natural waist of the TV405 pattern by almost two inches. I've asked around, and have been told to just fold the pattern pieces, but that method doesn't look like it will work at all on the back piece. Is there a better way of going about this than folding?
Folding it out, or cutting it out, they both pretty much are the same end result. The curved back seam will need some adjusting, though, to get the curve nice again. Basically, after your fold out what you need shortened, you will have this odd jog in the lines that will need to turned into a curve again. On the Back piece, cut away the jog bit, making a smooth curve from the waist to the armhole. The Side Back piece usually doesn't have as dramatic a jog, but you want to do the opposite, adding outside the curve to smooth the line out from waist to armhole. If that makes sense.
I guess where I'm mostly getting tripped up at is how the fold on the back is placed in relation to the natural waist. The portion that goes out (which is later turned into the fold) starts above where the natural waist is. How to I adjust that portion without affecting the fold on the back? I've uplaoded a picture of the area I'm talking about (just incase I'm not making sense. Plus I do way better with pictures).
- 100_3668.jpg (75.7 KiB) Viewed 2795 times
You don't want to change the pleat part at all. Fold it out above that point. Or, you can clip the pleat part to the stitching line, and the fold just the body part, keeping the pleat part untouched.
Who is online
Users browsing this forum: No registered users and 4 guests