Hello, just a quick question about the collar on the tv460 bodice.
How far is it supposed to sit back from the center front? I have less than an inch on either side after the collar and I think the collar is going to overlap once I get the bodice hooked up. I did do some shoulder and neckline alterations, so that would explain why the collar is too big, can I just trim off some of the end of the collar, or will that mess things up?
Find out how to get that dang thing to fit.
2 posts • Page 1 of 1
The collar is designed to just meet at the center front. Which would be 1" back from the raw edges. If it is too big, then yes, just trim the front until it fits. But also make sure that it is properly eased around the neckline so that it fits at the seam line, not just the raw edges.
Who is online
Users browsing this forum: No registered users and 3 guests