Hi, I´m back again. I had to sew some other things but now I´m back with my corset.
I was told that it was very important to use a fabric in the mockup as stong as the one I´m supposed to have in the real corset. The fabric I used last time was very strong but not that strong, so this time i use one I have been recomended for.
I used the same size but tried a smaller cup-size. It´s size B with A-cup. (Sorry that that the flash ruined the pictures a bit)
I think the bust is too small, it´s just pushing everything up so I will go back to B-cup again. I even realized a mistake I did on the last muckup wich can have made the bust bigger than it should have been.
The hips are a little bit loose.
Over all I am worried that the real corset will turn out too small with this size. There is a 4" wide panel in the back and there is no bones in yet and even now it´s supertight. I needed 6 layers extra strong thread to bast it together and when it was done it was almost like stone (don´t now any good english expression). Well, I do want it to be supertight like this, but I don´t want it to be too small. What do you think I should do?
Thank you so much for your help.
